I believe you're looking for g_auth_hide
On Jun 27, 2011, at 10:14 PM, Stan Greenspan wrote:
> We have a form on a webpage that uses a sendmail command. The page is supposed to send an e-mail to 2 addresses.
> The problem is that the sendmail engine does not allow for SMTP Auth
> All the mail will be coming from one IP address, and at this point will only be coming from one domain.
> Is there a way to set SurgeMail to ignore the SMTP Auth from a particular address/IP?
> Stan Greenspan
> Interactivepages Information Services
> Canada: 416 822 5671
> USA: 305 320 6593
> Legal Notice:
> This e-mail should be considered both privileged communication between the author and the addressee and copyright protected. Any retransmission, in whole or in part, without the written authorization of the author, shall be considered a breach of confidentiality and copyright.
Last Message | Next Message
Site Map |
Contact Netwin |
POP3 Mail Server |
Linux Webmail |
UnInstall instructions for all products
Copyright © 2017 Netwin Ltd. All rights reserved.